Cisco Official News: Important News: Cisco 300-206 Exam Questions are been updated recently! The Cisco 300-206 Practice Exam is a very hard exam to successfully pass your exam.Here you will find Free Braindump2go Cisco Practice Sample Exam Test Questions that will help you prepare in passing the 300-206 exam.Braindump2go Guarantees you 100% PASS exam JN0-360!
Exam Code: 300-206
Exam Name: Implementing Cisco Edge Network Security Solutions
Keywords: 300-206 Exam Dumps,300-206 Practice Tests,300-206 Practice Exams,300-206 Exam Questions,300-206 PDF,300-206 VCE Free,300-206 Book,300-206 E-Book,300-206 Study Guide,300-206 Braindump,300-206 Prep Guide
Which three configurations are needed to enable SNMPv3 support on the Cisco ASA? (Choose three.)
A. SNMPv3 Local EngineID
B. SNMPv3 Remote EngineID
C. SNMP Users
D. SNMP Groups
E. SNMP Community Strings
F. SNMP Hosts
Which two configurations are the minimum needed to enable EIGRP on the Cisco ASA appliance? (Choose two.)
A. Enable the EIGRP routing process and specify the AS number.
B. Define the EIGRP default-metric.
C. Configure the EIGRP router ID.
D. Use the neighbor command(s) to specify the EIGRP neighbors.
E. Use the network command(s) to enable EIGRP on the Cisco ASA interface(s).
All 30 users on a single floor of a building are complaining about network slowness. After investigating the access switch, the network administrator notices that the MAC address table is full (10,000 entries) and all traffic is being flooded out of every port. Which action can the administrator take to prevent this from occurring?
A. Configure port-security to limit the number of mac-addresses allowed on each port
B. Upgrade the switch to one that can handle 20,000 entries
C. Configure private-vlans to prevent hosts from communicating with one another
D. Enable storm-control to limit the traffic rate
E. Configure a VACL to block all IP traffic except traffic to and from that subnet
A network printer has a DHCP server service that cannot be disabled. How can a layer 2 switch be configured to prevent the printer from causing network issues?
A. Remove the ip helper-address
B. Configure a Port-ACL to block outbound TCP port 68
C. Configure DHCP snooping
D. Configure port-security
A switch is being configured at a new location that uses statically assigned IP addresses. Which will ensure that ARP inspection works as expected?
A. Configure the ‘no-dhcp’ keyword at the end of the ip arp inspection command
B. Enable static arp inspection using the command ‘ip arp inspection static vlan vlan- number
C. Configure an arp access-list and apply it to the ip arp inspection command
D. Enable port security
Which two voice protocols can the Cisco ASA inspect? (Choose two.)
You have explicitly added the line deny ipv6 any log to the end of an IPv6 ACL on a router interface. Which two ICMPv6 packet types must you explicitly allow to enable traffic to traverse the interface? (Choose two.)
A. router solicitation
B. router advertisement
C. neighbor solicitation
D. neighbor advertisement
Enabling what security mechanism can prevent an attacker from gaining network topology information from CDP?
B. Flex VPN
C. Control Plane Protection
D. Dynamic Arp Inspection
Which log level provides the most detail on the Cisco Web Security Appliance?
What is the lowest combination of ASA model and license providing 1 Gigabit Ethernet interfaces?
A. ASA 5505 with failover license option
B. ASA 5510 Security+ license option
C. ASA 5520 with any license option
D. ASA 5540 with AnyConnect Essentials License option
Braindump2go New Released 300-206 Dump PDF Free Download, 184 Questions in all, Passing Your Exam 100% Easily!